79 Search Results

A long-lived central engine embedded in expanding supernova ejecta can alter the dynamics and observational signatures of the event, producing an unusually luminous, energetic, and/or rapidly evolving transient. We use 2D hydrodynamics simulations to study the effect of a central energy source, varying the amount, rate, and isotropy of the energy deposition. We post-process the results with a time-dependent Monte Carlo radiation transport code to extract observational signatures. The engine excavates a bubble at the centre of the ejecta, which becomes Rayleigh–Taylor unstable. Sufficiently powerful engines are able to break through the edge of the bubble and accelerate, shred, andmore » compositionally mix the entire ejecta. The breakout of the engine-driven wind occurs at distinct rupture points, and the outflowing high-velocity gas may eventually give rise to radio emission. The dynamical impact of the engine leads to faster rising optical light curves, with photon escape facilitated by the faster expansion of the ejecta and the opening of low-density channels. For models with strong engines, the spectra are initially hot and featureless, but later evolve to resemble those of broad-line Ic supernovae. Under certain conditions, line emission from ionized, low-velocity material near the centre of the ejecta may be able to escape and produce narrow emission similar to that seen in interacting supernovae. We discuss how variability in the engine energy reservoir and injection rate could give rise to a heterogeneous set of events spanning multiple observational classes, including the fast blue optical transients, broad-line Ic supernovae, and superluminous supernovae.« less

Models from Coupled Model Intercomparison Project Phase 6 produce too much precipitation over the Andes but too little over the Amazon or the Wet Andes-Dry Amazon (WADA) bias pattern. Unlike the conventional view that convection parameterization and land model deficiencies can contribute to Amazonian rainfall biases, we approach this long-standing biased model behavior through the lens of Andean convection. Using Community Earth System Model v1.1 and focusing on the wet season, our mechanism-denial experiments demonstrate that Andean convection notably reduces precipitation over the Amazon during austral summer. The Andean forced Amazonian response operates on weather timescale. Furthermore, the reduction ofmore » Amazonian rainfall is detectable within a few hours after initial Andean forcing. The precipitation response is primarily driven by variations in the moisture budget and is moderated by changes in convective available potential energy over the Amazon. Changes in the total advection of moisture over the Amazon are dominated by the vertical advection term and can be attributed to discrepancies in the dynamic omega field. In the experiments, the Andean east flank region is scrutinized where the vertical velocity and moisture fields play an intermediary role for the Andean driven WADA connection. The Andean forcing induces descending anomalies on the Andean east flank. The disturbances of wind and geopotential fields over the Andean east flank propagate eastward via Kelvin waves. Over the Amazon, descending anomalies and advective drying lead to reduction of mid-to-high level cloud, increase of shortwave cloud forcing and surface net radiation, and enhancement of themodynamic stability and rainfall reduction.« less

Reactor dynamics simulations provide essential insights into the time-dependent behavior of nuclear reactors under various operating conditions. However, high-fidelity simulations can be computationally intensive, requiring significant computational resources. Here, to address this challenge, this study employs a differentiable hybrid model that utilizes neural networks as a corrector to enhance the performance of a low-fidelity simulation, aligning its predictions with those of a high-fidelity simulation. Low-fidelity and high-fidelity simulations were obtained by adjusting the mesh size in the System Dynamics Analysis Tool. The differentiable hybrid model was trained in two approaches: time-step-wise and sequence-wise. It was then applied to simulate variousmore » transients in a molten salt reactor. Its performance was evaluated by comparing its responses to transients against those of the high-fidelity simulation. An additional approach was performed using a data-driven model to correct the low-fidelity simulation. In comparison, the differentiable hybrid model showed significant improvements in transient prediction, effectively addressing the limitations of the low-fidelity simulations. The results highlighted the robustness of the differentiable hybrid model in both training approaches. It delivered simulations that were at least 3.8 times faster than high-fidelity models. In the time-step-wise approach, it achieved at least a 39% improvement in accuracy. In the sequence-wise approach, it showed at least an 81% accuracy improvement over the full transient. This approach offers a promising path for improving computational efficiency without compromising accuracy in nuclear reactor simulations, making it suitable for real-time digital twin applications.« less

Heat pipes are advanced passive thermal management devices that utilize phase change and capillary action to achieve efficient heat transfer. However, due to the complexity of the phenomena coupled in heat pipes, including capillary, phase change, turbulence, and compressibility effects, there are high uncertainties in the predictability of their operational regimes and performance. This PIRT exercise, conducted as a collaborative effort involving the Department of Energy (DOE) Microreactor Program (MRP), the Nuclear Regulatory Commission (NRC), and university partners systematically identifies, reviews, and prioritizes critical phenomena affecting the operation of heat pipes based on their importance and knowledge levels. Additional analysesmore » and discussion are provided for phenomena with high importance and low knowledge, such as wick de-wetting, critical heat flux, contact angles, and pressure dynamics. The discussions included the recognizing challenges and proposing future research directions for both modeling and simulation and experimental efforts. Additionally, the report addresses phenomena with medium importance and low knowledge that could impact heat pipe operation during non-normal or transient operation, including frozen startup, laminar to turbulent transition, geyser boiling, wick priming, underfilling conditions, surface roughness of the wick, NCGs trapped in the wick, and the timescales of startup and shutdown. In conclusion, this comprehensive evaluation serves as a valuable resource for guiding future research and development efforts, supporting the successful integration of heat pipes into critical applications such as nuclear reactors, and contributing to the advancement of heat pipe technologies in safety-critical industries.« less

Cross slip is a dislocation mechanism that significantly impacts the mechanical behavior of engineering alloys. Here, in this work, we advance a 3D phase-field dislocation dynamics (PFDD) mesoscale technique to simulate cross slip across a broad range of face-centered cubic (FCC) metals. The formulation incorporates elastic anisotropy, an FCC numerical grid, and a high-fidelity representation of the entire γ-surface from density functional theory for eight FCC metals and no adjustable parameters or rules. The relaxed core structures under zero stress for all metals are predicted to extend in plane. The analytical model for stacking fault width agrees well with themore » PFDD result under the assumption of elastic isotropy but overestimates it under elastic anisotropy, when the degree of anisotropy is large. The dynamic simulations are designed to elucidate the material parameters that influence the propensity for cross slip. Whether cross slip occurs under a non-Schmid stress or to bypass a hard obstacle, the critical stress to cross slip scales strongly with the anisotropic energy coefficient for a screw dislocation.« less

Alquimia v1.0 is a generic interface to geochemical solvers that facilitates development of multiphysics simulators by enabling code coupling, prototyping and benchmarking. The interface enforces the function arguments and their types for setting up, solving, serving up output data and carrying out other common auxiliary tasks while providing a set of structures for data transfer between the multiphysics code driving the simulation and the geochemical solver. Alquimia relies on a single-cell approach that permits operator splitting coupling and parallel computation. We describe the implementation in Alquimia of two widely used open-source codes that perform geochemical calculations: PFLOTRAN and CrunchFlow. Wemore » then exemplify its use for the implementation and simulation of reactive transport in porous media by two open-source flow and transport simulators: Amanzi and ParFlow. We also demonstrate its use for the simulation of coupled processes in novel multiphysics applications including the effect of multiphase flow on reaction rates at the pore scale with OpenFOAM, the role of complex biogeochemical processes in land surface models such as the E3SM Land Model (ELM) and the impact of surface–subsurface hydrological interactions on hydrogeochemical export from watersheds with the Advanced Terrestrial Simulator (ATS). These applications make it apparent that the availability of a well-defined yet flexible interface has the potential to improve the software development workflow, freeing up resources to focus on advances in process models and mechanistic understanding of coupled problems.« less

The Cosmological Advanced Survey Telescope for Optical and UV Research (CASTOR) is a planned flagship space telescope, covering the blue-optical and UV part of the spectrum. Here, we introduce the CASTOR image simulator, a python GalSim package-based script capable of generating mock CASTOR images from an input catalogue. We generate example images from the CASTOR Wide, Deep, and Ultra-Deep surveys using simulated lightcones from the Santa Cruz semi-analytic model. We make predictions for the performance of these surveys by comparing galaxies that are extracted from each image using Source Extractor to the input catalogue. We find that the Wide, Deep,more » and Ultra-Deep surveys will be 75 per cent complete for point sources down to $$\sim 27$$, 29, and 30 mag, respectively, in the UV, u, and g filters, with the UV-split and u-split filters reaching a shallower depth. With a large area of $$\sim 2200$$ deg$^2$, the Wide survey will detect hundreds of millions of galaxies out to $$z\sim 4$$, mostly with $$M_\ast \gtrsim 10^{9}\,{\rm M}_{\odot }$$. The Ultra-Deep survey will probe to $$z\sim 5$$, detecting galaxies with $$M_\ast \gtrsim 10^{7}{\rm M}_{\odot }$$. These galaxy samples will enable precision measurements of the distribution of star formation in the cosmic web, connecting the growth of stellar mass to the assembly of dark matter haloes over two thirds of the history of the Universe, and other core goals of CASTOR’s legacy surveys. These image simulations and the tools developed to generate them will be a vital planning tool to estimate CASTOR’s performance and iterate the telescope and survey designs prior to launch.« less

Nuclear astrophysics is an interdisciplinary field focused on exploring the impact of nuclear physics on the evolution and explosions of stars and the cosmic creation of the elements. While researchers in astrophysics and in nuclear physics are separately using machine learning approaches to advance studies in their fields, there is currently little use of machine learning in nuclear astrophysics. We briefly describe the most common types of machine learning algorithms, and then detail their numerous possible uses to advance nuclear astrophysics, with a focus on simulation-based nucleosynthesis studies. We show that machine learning offers novel, complementary, creative approaches to addressmore » many important nucleosynthesis puzzles, with the potential to initiate a new frontier in nuclear astrophysics research.« less

Applications of new techniques in machine learning are speeding up progress in research in various fields. In this work, we construct and evaluate a deep neural network (DNN) to be used within a Bayesian statistical framework as a faster and more reliable alternative to the Gaussian process (GP) emulator of an isospin-dependent Boltzmann-Uehling-Uhlenbeck (IBUU) transport model simulator of heavy-ion reactions at intermediate beam energies. We found strong evidence of the DNN being able to emulate the IBUU simulator's prediction on the strengths of protons' directed and elliptical flow very efficiently even with small training datasets and with accuracy about tenmore » times higher than the GP. Here, limitations of our present work and future improvements are also discussed.« less

Iron phosphate glasses, known for their exceptional chemical durability and potential applicability in nuclear waste management, have gained significant attention over the years. The structures of these glasses are complicated by the coexistence of Fe³⁺ and Fe²⁺, which plays a crucial role in determining their structures and properties. Here, this work uses molecular dynamics simulations to study the structural changes in Na₂O–Fe₂O₃–P₂O₅ glasses with varying glass composition and Fe²⁺/Fe³⁺ redox ratio. It was found that the redox ratio and modifier contents significantly affected the short-range and medium-range orders in the glasses. Significant changes in the local environments around P⁵⁺ andmore » Fe³⁺ were observed, as reflected by the bond distances and coordination numbers. Na⁺ cations are found to preferentially associate with Fe³⁺ (rather than Fe²⁺), whereas Fe²⁺ has stronger association with P⁵⁺ than Na⁺, confirming the structural role of Fe²⁺ as a glass modifier. The disruptions in P–O–P linkages upon increasing FeO suggest that FeO causes glass depolymerization. These glasses achieved higher connectivity with increasing Fe³⁺ / (Fe³⁺ + Fe²⁺) ratios, conerting phosphorous Q₂ to Q₃ units and iron Q₅ units to Q₄ units. The decrease of nonbridging oxygen fractions with increasing Fe³⁺ / (Fe³⁺ + Fe²⁺) ratios, through creating P–O–Fe linkages, is the main reason of enhanced network connectivity. Quantitative structure–property relationship analyses with different structural descriptors were used to correlate with measured properties. The analyses provided valuable insights into structure–property relationships, emphasizing the importance of choosing relevant energy parameters and defining glass network connectivity, particularly in F_net descriptors. It was found the Fe–O–P linkage density exhibits strong correlations to measured dissolution rates, supporting the importance of these linkages in improving the chemical durability in iron phosphate glasses.« less